Panasonic KX-NS1000 Installation Manual page 200

5.4.1 Easy Setup Wizard
<At a Slave Unit>
Click Import to import the setting file exported from the Master unit.
Note
•
The settings become active after restarting the Slave unit.
•
In the imported data, if the VPSS's Master Site IP Address (WAN) cannot be resolved, a
window for setting the Master Site IP Address (WAN) is displayed. Set the Master Site IP
Address (WAN). This setting can also be set later.
For details, refer to "27.9 Router Configuration—VPN—[3-1] VPSS" in the PC Programming
Manual.
e.
Click Next.
When not using the built-in router:
a.
In Built-in Router—Connection Mode, select Disable.
b.
Click Next.
*1
Valid IP address range: "1.0.0.1" to "223.255.255.254"
*2 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
*3 Up to 64 characters.
*4
Up to 24 characters.
6.
In Registration Setting, the IP Terminal Registration Mode and the One Look Networking (Trial
Activation Key) can be set.
a.
Select the IP Terminal Registration Mode:
•
Manual: Select this mode to manually register IP terminal information.
•
Full Automatic: Select this mode to automatically register IP terminal information.
•
Extension Number Input: Select this mode to automatically register IP terminal information except
its extension number. The extension number can then be registered from the IP telephone
manually.
Note
•
Full Automatic and Extension Number Input registration methods may not be available for
certain types of IP terminals. In such cases, select the Manual registration method.
•
For more information about the IP terminal registration modes, refer to "5.9.1 Registering
IP Telephones".
b.
For One Look Networking (Trial Activation Key), specify whether to activate the 60-day One-look
Networking Trial Activation Key.
–
If Active is selected, the 60-day trial will begin when the Easy Setup Wizard is completed.
–
If Non Active is selected, you will have to activate the trial manually in order to use One-look
Networking Features on a trial basis.
c.
Click Next.
If Slave has been selected in step 2, the Easy Setup Wizard will finish at this step. If LAN settings have
been changed from their default values in step 4, you will be prompted to restart the PBX. Click OK to
restart the PBX.
To add the PBX as a Slave unit PBX to the One-look network, use the Add Site Wizard from the Master
unit PBX's Home Screen.
7.
In SNTP / Daylight Saving, enter information for Automatic Time Adjustment and Daylight Saving, and
then click Next.
8.
In Maintenance Setting, the Installer password, information for SNMP Setting and SNMP Manager can
be entered.
a.
Enter a password for the Installer level account in Installer password. Confirm your input in
Re-enter.
200 Installation Manual Document Version 2016-03