Panasonic KX-NS1000 Installation Manual page 235

The PBX's IP address must be assigned manually on the SIP phone side.
For instructions, refer to the documentation of the SIP phone.
Not using a DHCP server (DHCP Server feature or an external DHCP server) when assigning IP
addressing information
All of the IP addressing information must be assigned manually.
For instructions, refer to the documentation of the SIP phone.
Note
•
A SIP phone can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when SIP phones are located on several LANs, a DHCP server is required on each LAN.
•
When the DHCP client function is enabled for SIP phones, simply connect them to the LAN to use the
DHCP server. For details about the DHCP client function setting, refer to the documentation of the SIP
phone.
For IP-CSs
Using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on the same
LAN as the PBX
The DHCP server automatically assigns the IP address of the IP-CS, the subnet mask address, and the default
gateway address to the IP-CS.
The PBX's IP address can also be assigned automatically to the IP-CS in the process of being registered to
the PBX. For details about registering the IP-CS, refer to "5.9.1 Registering IP Telephones" and corresponding
manuals for the IP-CS.
Note
For information about the DHCP Server feature, refer to "8.1.2 DHCP (Dynamic Host Configuration
Protocol) Server".
Using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on a remote
office LAN
While the DHCP server automatically assigns the IP address of the IP-CS, the subnet mask address, and the
default gateway address to the IP-CS, the PBX's IP address must be assigned manually.
To assign the PBX's IP address, refer to corresponding manuals for the IP-CS.
If you need to set VLAN parameters, refer to the corresponding manuals for the IP-CS.
Note
•
By assigning the PBX's IP address to one IP-CS (KX-NS0154 only), it is possible to assign the PBX's
IP address to other IP-PTs or IP-CSs on the same LAN through system programming. For details, refer
to "9.19 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Port Property—Option—
Announce Mode" in the PC Programming Manual.
•
IP-CSs can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when IP-CSs are located on several LANs, a DHCP server is required on each LAN.
•
Since the default setting of the DHCP client function is enabled for IP-CSs, simply connect the IP-CSs
to the LAN to use the DHCP server.
Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on the
same LAN as the PBX
Only the PBX's IP address can be assigned automatically to the IP-CS in the process of being registered to
the PBX. For details about registering the IP-CS, refer to "5.9.1 Registering IP Telephones" and corresponding
manuals for the IP-CS.
To assign the IP address of the IP-CS, the subnet mask address, and the default gateway address manually,
refer to corresponding manuals for the IP-CS.
If you need to set VLAN parameters, refer to corresponding manuals for the IP-CS.
Document Version 2016-03
5.8.1 Assigning IP Addressing Information
Installation Manual 235