Panasonic KX-NS1000 Installation Manual page 278

5.9.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
Setting up KX-UT series SIP phones without connecting to the KX-NS1000 at the main site,
and then sending them to the remote site
1.
Log in to Web Maintenance Console of the site where the SIP phones will be registered. For details about
logging in to a Slave unit via the Master unit, refer to "3.1 Home Screen" in the PC Programming Manual.
2. Click Utility ® File ® File Transfer PBX to PC.
3.
Select the config file according to the protocol used and then download it to your PC.
•
If HTTPS is used:
–
UT_MRG_HTTPS_xxyyyy.cfg
For more details about downloading files from a PBX to a PC, refer to "7.2.2 Utility—File—File Transfer
PBX to PC" in the PC Programming Manual.
Note
xx: Site ID (2 digits)
yyyy: Site name
*1 Spaces as well as the following characters in site names will be replaced with underscores.
/, :, *, ?, ", <, >, | (vertical bar), &, +
*2 In some cases, the full site name may not be included in the file name even if it is less than 32 characters.
4.
Download the config file to the KX-UT series SIP phone via the Web user interface of the KX-UT series
SIP phone. For details, refer to "When the SIP Phones are in a different LAN (Remote site installation)" in
"5.8.1 Assigning IP Addressing Information".
5.
Connect the KX-UT series SIP phone to the LAN in the remote site.
6.
Register the KX-UT series SIP phone to the KX-NS1000 as a remote extension.
Click Setup ® PBX Configuration ® Configuration ® Slot.
a.
b. Click Virtual ® V-UTEXT32.
c.
Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location.
•
Change the value to Enable for Web-MC Ability.
•
Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT.
Note
Select the same value as you selected for NAT - SIP Proxy Server Port No. in step 5 of
"Programming the KX-NS1000" in this section.
g.
Click OK.
7.
Register the KX-UT series SIP phone. For details, refer to "5.9.1 Registering IP Telephones".
Note
•
You can select HTTPS for Protocol for Remote SIP-MLT only when Phone Location is set as
Remote (MRG).
•
If the KX-UT series SIP phone does not work normally, confirm whether the KX-UT series SIP
phone can access the internet.
278 Installation Manual
(Up to 32 characters )
*1 *2
Document Version 2016-03