Connection Mode setting
DHCP
PPPoE
Disable
PPPoE Additional Settings
Specify the following settings:
Settings
User Name
*3
Password
*3
Service Name
WAN IP Address
Subnet Mask
Gateway
*1
Preferred DNS IP Address
Alternative DNS IP Address
Note
•
For details about configuring the parameters, refer to "27.2.1 Router
Configuration—Setup—[1-2-1] WAN—Connection Settings" in the PC Programming Manual.
•
For details about the values to set for the parameters, consult the network administrator.
c.
In IPSec (VPN) Connection (Trial Activation Key), select Simple Configuration –VPSS.
Note
•
The IPSec feature will operate until the trial activation key expires. To continue using the IPSec
feature, the activation key (KX-NSN216) is required.
•
For details about manually changing parameters related to inter-site connections via IPSec
established by VPSS, refer to "27.9 Router Configuration—VPN—[3-1] VPSS" in the PC
Programming Manual.
d.
<At the Master Unit>
Click Export to export the setting file.
The setting file created by the Master unit PBX is required to add a Slave unit to the network.
Note
The Export button will also be available when adding a Slave unit.
Document Version 2016-03
•
If you select Obtain From DHCP in DNS Setting,
address information is obtained from the DHCP
server.
•
If you select Static in DNS Setting specify the
following settings:
–
–
Refer to "PPPoE Additional Settings".
The built-in router does not operate
Dynamic IP
*4
*1
*2
*1
*1
Additional settings
Preferred DNS IP Address
Alternative DNS IP Address
Address Conf. Mode
Unnumbered
ü
ü
ü
ü
ü
ü
ü
5.4.1 Easy Setup Wizard
*1
*1
Static IP
ü
ü
ü
ü
ü
ü
ü
Installation Manual
199