Panasonic KX-NS1000 Installation Manual page 201

Note
The installer password must be changed from its default setting.
b.
Specify settings for SNMP Setting and SNMP Manager if necessary. If you are unsure of your
network's SNMP settings, contact your network's administrator.
c.
Click Finish.
9.
Follow the prompts of the Easy Setup Wizard. After the Easy Setup Wizard is completed, if LAN settings
have been changed from their default values in step 4, you will be prompted to restart the PBX. Click OK
to restart the PBX. Otherwise, the login screen will be displayed.
10.
Log in with the Installer level account using the password entered during Easy Setup Wizard.
The Home Screen is displayed. You may now begin programming the PBX.
Notice
If an external DHCP server is in use, it must be able to use a "client identifier" option specified by RFC 2131.
Changing IP Address Settings
IP addressing information for the PBX can also be changed from Web Maintenance Console after the Easy
Setup Wizard has been completed.
1. Click Setup ® Network Service ® IP Address/Ports.
2.
Click the Basic Settings tab.
3. When using a DHCP server:
a.
Select Obtain an IP address automatically.
b.
Select Obtain DNS server address automatically.
c.
Select Obtain DSP IP address automatically.
Notice
The boxes will turn grey and the IP address information will be assigned automatically.
Write down the address information assigned to the PBX for future reference.
When not using a DHCP server:
a.
Select Use the following IP address.
b.
Enter an IP address
(The default gateway may not need to be specified depending on your network configuration.)
c.
Select Use the following DNS server address.
d.
Enter the preferred and alternative DNS IP addresses
e.
Select Use the following DSP IP address.
f.
Enter up to 2 IP addresses
4.
Click OK.
a.
A screen will appear stating that any changes made in step 3 will be activated after the PBX is restarted.
b.
Click OK.
5.
Restart the PBX.
a. Click Maintenance ® System Control ® System Reset.
b.
On the System Reset screen, click Backup.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
*2
Notice
•
Do not change the IP address of the PBX once IP telephones are registered to the PBX using the set
IP address. The IP telephones will not operate properly if the IP address of the PBX is changed. When
an external DHCP server is used to automatically assign IP addresses, it must be configured to always
allocate the same IP address to the PBX. For details, consult your network administrator.
Document Version 2016-03
, Subnet Mask , and Default Gateway
*1 *2
for each installed DSP card.
*1
5.4.1 Easy Setup Wizard
.
*1
.
*1
Installation Manual 201