Ipv6 Lan Settings - D-Link DWC-1000 User Manual

Section 5 - Advanced Network Configuration
Path: Network > IPv6 > LAN Settings > IPv6 LAN Settings
In IPv6 mode, the LAN DHCP server is disabled by default (similar to IPv4 mode). The DHCPv6 server will serve
IPv6 addresses from configured address pools with the IPv6 Prefix Length assigned to the LAN.
The default IPv6 LAN address for the controller is fec0::1. You can change this 128 bit IPv6 address based on your
network requirements. The other field that defines the LAN settings for the controller is the prefix length. The
IPv6 network (subnet) is identified by the initial bits of the address called the prefix. By default, this is 64 bits long.
All hosts in the network have common initial bits for their IPv6 address; the number of common initial bits in the
network's addresses is set by the prefix length field.
1. Go to Network > IPv6 > LAN Settings > IPv6 LAN Settings tab.
2. Complete the fields in the table below and on the next page.
3. Click Save.
Field
IPv6 Address
IPv6 Prefix Length
D-Link DWC-1000 User Manual

IPv6 LAN Settings

LAN TCP/IP Setup
The Wireless Controller's LAN IPv6 address.
The IPv6 network (subnet) is identified by the initial bits of the address called the prefix.
All hosts in the network have the identical initial bits for their IPv6 address; the number
of common initial bits in the networks addresses are set by the prefix length field.
Description
141