D-Link DWC-1000 User Manual page 185

Section 5 - Advanced Network Configuration
Field Description
OSPFv3 Enable Toggle ON to enable OSPFv3.
Interface
Displays the physical network interface on which OSPFv3 is Enabled/Disabled.
Helps to determine the OSPFv3 designated controller for a network. The controller with the
highest priority will be more eligible to become Designated Controller. Setting the value to
Priority
0 makes the controller ineligible to become Designated Controller. The default value is 1.
Lower the value means higher the priority.
The number of seconds for Hello Interval timer value. Enter the number in seconds that
Hello Interval
the Hello packet will be sent. This value must be the same for all controllers attached to a
common network. The default value is 10 seconds.
The number of seconds that a device's hello packets must not have been seen before its
neighbors declare the OSPF controller down. This value must be the same for all controllers
Dead Interval attached to a common network. The default value is 40 seconds. OSPF requires these
intervals to be exactly the same between two neighbors. If any of these intervals are
different, these controllers will not become neighbors on a particular segment.
Cost Enter the cost of sending a packet on an OSPFv3 interface.
Save Click Save to save your settings.
D-Link DWC-1000 User Manual 185