Spillover - D-Link DWC-1000 User Manual

Section 5 - Advanced Network Configuration
1. Click Network > Internet (IPv4) > Option Mode.
2. Complete the fields from the table below and click Save.
Field
Option Mode
Load Balance
DNS Lookup Mode
Retry Interval is
Failover After
Load Tolerance
Max Bandwidth
Save
D-Link DWC-1000 User Manual
Select Load Balancing from the drop-down menu.
Select Spillover Mode.
• Option DNS Servers: DNS Lookup of the DNS Servers of the primary link is used to detect
primary Option connectivity.
• DNS Servers: DNS Lookup of the custom DNS Servers can be specified to check the
connectivity of the primary link.
• Ping these IP addresses: These IP's will be pinged at regular intervals to check the
connectivity of the primary link.
Enter the time in seconds to initiate the DNS Lookup Mode. Default is every 30 seconds. The
number tells the controller how often it should run the above configured failure detection
method.
Enter the number of failures before the controller initiates the failover process.
Enter the percentage of bandwidth after which the controller switches to the secondary Option.
This sets the maximum bandwidth tolerable by the primary Option for outbound traffic.
Click save to activate your settings.

Spillover

Description
165