Client - D-Link DWC-1000 User Manual

Section 7 - VPN
Path: VPN > PPTP VPN > Client
PPTP VPN Client can be configured on this switch. Using this client, you can access remote network which is
local to PPTP server. Once client is enabled, the user can access Status > Active VPNs page and establish PPTP
VPN tunnel by clicking Connect.
To configure the switch as a PPTP VPN client:
1. Click VPN > PPTP VPN > Client tab.
2. Toggle Client to ON and complete the fields in the table below.
Field

Client

Server IP
Remote Network
Remote Netmask
Username
Password
MPPE Encryption
Idle Time Out
Save
D-Link DWC-1000 User Manual
Toggle to ON to enable PPTP client.
Enter the IP address of the PPTP server you want to connect to.
Enter the remote network address. This address is local for the PPTP Server.
Enter the remote network subnet mask.
Enter your PPTP user name.
Enter your PPTP password.
Toggle to ON to enable Microsoft Point-to-Point Encryption (MPPE).
Enter the amount of time (in seconds) that you will disconnect from the PPTP server when idle.
Click Save to save and activate your settings.
Client
Description
263