Pptp Vpn; Server - D-Link DWC-1000 User Manual

Section 7 - VPN
Path: VPN > PPTP VPN > Server
A PPTP VPN can be established through this switch. Once enabled a PPTP server is available on the switch for
LAN and Option PPTP client users to access. Once the PPTP server is enabled, PPTP clients that are within the
range of configured IP addresses of allowed clients can reach the controller's PPTP server. Once authenticated
by the PPTP server (the tunnel endpoint), PPTP clients have access to the network managed by the controller.
The range of IP addresses allocated to PPTP clients can coincide with the LAN subnet. The PPTP server will default
to local PPTP user authentication, but can be configured to employ an external authentication server.
To create a PPTP VPN server:
1. Click VPN > PPTP VPN > Server.
2. Complete the fields in the table below and click Save.
Field
Enable PPTP Server
PPTP Routing Mode
Starting/Ending IP Address
IPv6 Prefix
IPv6 Prefix Length
Authentication
Authentication Supported
Idle TimeOut
NetBIOS
Save
D-Link DWC-1000 User Manual

PPTP VPN

Server

Select either IPv4 or IPv6.
Select either NAT or Classical.
Enter the IP address range to assign your PPTP clients.
If you selected IPv6, enter the IPv6 prefix.
If you selected IPv6, enter the IPv6 prefix length.
Select the authentication type from the drop-down menu.
Toggle which type of authentication you want to enable to ON.
Enter the amount of time in seconds that the connection will disconnect when idle.
Toggle to ON to allow NetBIOS broadcasts to travel over the VPN tunnel.
Click to save your settings.
Description
262