Missing Drives Commands; Set Drive State Commands - Lenovo ThinkServer RD650 User Manual

12Gb/s MegaRAID SAS Software User Guide
March 2014
6.6.3.2

Missing Drives Commands

The Storage Command Line Tool supports the following commands to mark and replace missing physical drives:
storcli /cx[/ex]/sx insert dg=A array=B row=C
storcli /cx[/ex]/sx set missing
storcli /cx[/ex]/sx set offline
storcli /cx/dall
The detailed description for each command follows.
storcli /cx[/ex]/sx insert dg=A array=B row=C
This command replaces the configured drive that is identified as missing, and then starts an automatic rebuild.
Input example:
storcli /c0/e25/s3 insert dg=0 array=2 row=1
storcli /cx[/ex]/sx set missing
This command marks a drive as missing.
Input example:
storcli /c0/s4 set missing
storcli /cx/dall
This command is used to find the missing drives.
storcli /cx[/ex]/sx set offline
This command marks the drive in an array as offline.
6.6.3.3

Set Drive State Commands

The Storage Command Line Tool supports the following commands to set the status of physical drives:
storcli /cx[/ex]/sx set jbod
storcli /cx[/ex]/sx set good [force]
storcli /cx[/ex]/sx set offline
storcli /cx[/ex]/sx set online
storcli /cx[/ex]/sx set missing
storcli /cx[/ex]/sx set bootdrive=<on|off>
The detailed description for each command follows.
storcli /cx[/ex]/sx set jbod
This command sets the drive state to JBOD.
Input example:
storcli /c1/e56/s3 set jbod
storcli /cx[/ex]/sx set good [force]
This drive changes the drive state to unconfigured good. If the drive has the operating system in it, use the
force option.
NOTE The storcli /cx/sx show all command shows tape drives
information.
NOTE To set a drive that is part of an array as missing, first set it as offline. After
the drive is set to offline, you can then set the drive to missing.
LSI Corporation
- 172 -
Chapter 6: StorCLI
Working with the Storage Command Line Tool