12Gb/s MegaRAID SAS Software User Guide
March 2014
Description
Set battery properties
Start battery learn cycle.
Set the battery to low power
storage mode.
Seal the gas gauge EEPROM
write access
MegaCLI Command
MegaCli -AdpBbuCmd
-SetBbuProperties -f <fileName>
-aN|-a0,1,2|-aALL
MegaCli -AdpBbuCmd -BbuLearn
-aN|-a0,1,2|-aALL
MegaCli -AdpBbuCmd -BbuMfgSleep
-aN|-a0,1,2|-aALL
MegaCli -AdpBbuCmd -BbuMfgSeal
-aN|-a0,1,2|-aALL
Appendix C: MegaCLI Commands to StorCLI Command Conversion
storcli /cx/bbu set
learnDelayInterval=<value>
storcli /cx/bbu set bbuMode=<value>
storcli /cx/bbu set autolearnmode=<value>
where x= 0 – Enabled, 1 – Disabled, 2 – Warn though
event.
storcli /cx/bbu start learn
storcli /cx/bbu set powermode=sleep
storcli /cx/bbu set writeaccess=sealed
LSI Corporation
- 390 -
Battery Commands
StorCLI Command