Lenovo ThinkServer RD650 User Manual page 346

12Gb/s MegaRAID SAS Software User Guide
March 2014
Figure 229 Enable Drive Security – Security Key Identifier
3. Either use the default security key identifier, or enter a new security key identifier.
4. Either click Suggest Security Key to have the system create a security key, or you can enter a new security key.
5. Enter the new security key again to confirm.
The security key is case-sensitive. It must be between 8 and 32 characters and contain at least one number, one
lowercase letter, one uppercase letter, and one non-alphanumeric character (e.g., < > @ +). The space character is
not permitted.
The following figure shows the security key entered and confirmed on this dialog.
NOTE If you create more than one security key, make sure that you change
the security key identifier. Otherwise, you cannot differentiate
between the security keys.
CAUTION If you forget the security key, you will lose access to your data. Be
sure to record your security key information. You might need to enter
the security key to perform certain operations.
NOTE Non-U.S. keyboard users must be careful not to enter double-byte
character set (DBCS) characters in the security key field. The firmware
works with the ASCII character set only.
LSI Corporation
- 346 -
Chapter 12: Using MegaRAID Advanced Software
LSI MegaRAID SafeStore Encryption Services