Installing Storcli On Vmware Operating Systems; Installing Storcli On Freebsd Operating Systems; Installing Storcli On Microsoft Efi; Installing Storcli On Solaris Operating Systems - Lenovo ThinkServer RD650 User Manual
12 gb/s megaraid sas
Hide thumbs
Also See for ThinkServer RD650:
- User manual and hardware maintenance manual (262 pages) ,
- Operating system installation manual (122 pages) ,
- User manual (226 pages)
Table of Contents
Advertisement
12Gb/s MegaRAID SAS Software User Guide
March 2014
1.
Run the command sudo dpkg -i storcli_1.0_all.deb for installing the Debian package.
2.
Run the command dpkg -l | grep -i storcli for verifying if the Debian package was installed
successfully or not.
3.
To uninstall the Debian package, run the command, sudo dpkg –r storcli.
6.4.4
Installing StorCLI on VMware Operating Systems
To install StorCLI on VMware operating systems, run the following syntax from the command line:
esxcli software vib install –v=<path-to-vib-package>
Example:
esxcli software vib install
-v=/vmfs/volumes/datastore1/StorCliMN/vmware-esx-StorCli-1.01.04.vib
6.4.5
Installing StorCLI on FreeBSD Operating Systems
The FreeBSD StorCLI binary is provided in a binary format, and no separate installation is required.
1.
Copy the binary file from the CD or from the LSI website.
2.
Place the binary file in the directory from which you want to run the Storage Command Line Tool, and run
the tool.
6.4.6
Installing StorCLI on Microsoft EFI
The EFI StorCLI binary is provided in a binary format, and no separate installation is required.
1.
Copy the binary file from the CD or from the LSI website.
2.
Place the binary file in the directory from which you want to run the Storage Command Line Tool, and run
the tool.
6.4.7
Installing StorCLI on Solaris Operating Systems
To install StorCLI on Solaris operating systems, run the following command:
pkgadd –d Storcli.pkg
6.5
StorCLI Command Syntax
This chapter describes the StorCLI command syntax and the valid values for each parameter in the general
command syntax.
NOTE
Run all the commands using the super user (sudo) login.
NOTE
To get the output in JSON format, add J at the end of the command
syntax.
Example: storcli /cx show <property1>|<property2>
J
LSI Corporation
- 157 -
Chapter 6: StorCLI
StorCLI Command Syntax
Advertisement
Table of Contents
