Figure 103. I/O-module-board connectors for cable routing
Notes:
• Depending on the specific configuration, the I/O module board might look different from the illustrations in
this section.
Table 3. I/O-module-board connectors for cable routing
I/O-module-board power connector
1
Cable routing for the hot-swap drives
Follow instructions in this section to learn how to do cable routing for the 15mm and 7mm 2.5-inch hot-swap
drives.
Identifying connectors on the drive backplanes
The following illustration shows the connectors on the drive backplanes that are used for internal cable
routing.
Figure 104. Connectors for cable routing on Drive
backplane 1 (lower)
Table 4. Backplane connectors for cable routing
Drive-backplane 1 power connector
1
Drive-backplane 1 MCIO connector for NVMe
2
Power connector for Drive Backplane 1 (lower)
2
Figure 105. Connector for cable routing on Drive
backplane 2 (upper)
Drive-backplane 1 MCIOx4 connector for SATA
3
Drive-backplane 2 MCIO connector for NVMe
4
Chapter 2
.
Internal cable routing
129