Phy Commands - Lenovo ThinkServer RD650 User Manual
12 gb/s megaraid sas
Hide thumbs
Also See for ThinkServer RD650:
- User manual and hardware maintenance manual (262 pages) ,
- Operating system installation manual (122 pages) ,
- User manual (226 pages)
Table of Contents
Advertisement
12Gb/s MegaRAID SAS Software User Guide
March 2014
storcli /cx/ex show status
The detailed description for each command follows.
storcli /cx/ex download src=filepath [forceactivate]
This command flashes the firmware with the file specified at the command line. The enclosure performs an error
check after the operation. The following option can be used with the enclosure firmware download command.
Table 54 Enclosure Firmware Download Command Options
Option
forceactivate
Input example:
storcli /c0/e0 download src=c:\file2.bin
storcli /cx/ex show all
This command shows all enclosure information, which includes general enclosure information, enclosure inquiry data,
a count of enclosure elements, and information about the enclosure elements.
Input example:
storcli /c0/e0 show all
storcli /cx/ex show status
This command shows the enclosure status and the status of all the enclosure elements.
Input example:
storcli /c0/e0 show status
6.6.12
PHY Commands
The Storage Command Line Tool supports the following PHY commands:
storcli /cx/px|pall set linkspeed=0(auto)|1.5|3|6|12
storcli /cx/px|pall show
storcli /cx/px|pall show all
The detailed description for each command follows.
storcli /cx/px|pall set linkspeed=0(auto)|1.5|3|6|12
This command sets the PHY link speed. You can set the speed to 1.5 Gb/s, 3 Gb/s, 6 Gb/s, or 12 Gb/s. The linkspeed is
set to auto when you specify linkspeed = 0.
Input example:
storcli /c0/p0 set linkspeed=1.5
storcli /cx/px|pall show
This command shows the basic PHY layer information.
Input example:
Value Range
—
Issues a command descriptor block (CDB) with write command with no data with command
mode 0x0F (flash download already in progress).
NOTE This option is used primarily to activate Scotch Valley Enclosures.
NOTE
The firmware file that is used to flash the enclosure can be of any
format. The StorCLI utility assumes that you provide a valid firmware
image.
Description
LSI Corporation
- 196 -
Chapter 6: StorCLI
Working with the Storage Command Line Tool
Advertisement
Table of Contents
