Drive Commands; Drive Show Commands - Lenovo ThinkServer RD650 User Manual
12 gb/s megaraid sas
Hide thumbs
Also See for ThinkServer RD650:
- User manual and hardware maintenance manual (262 pages) ,
- Operating system installation manual (122 pages) ,
- User manual (226 pages)
Table of Contents
Advertisement
12Gb/s MegaRAID SAS Software User Guide
March 2014
6.6.3
Drive Commands
This section describes the drive commands, which provide information and perform actions related to physical drives.
The following table describes frequently used virtual drive commands.
Table 44 Physical Drives Commands Quick Reference Table
Commands
set
show
6.6.3.1
Drive Show Commands
The Storage Command Line Tool supports the following drive show commands:
storcli /cx[/ex]/sx show
storcli /cx[/eall]/sall show
storcli /cx[/ex]/sx|sall show all
The detailed description for each command follows.
storcli /cx[/ex]/sx show
This command shows the summary of the physical drive for a specified slot in the controller.
Input example:
storcli /c0/e0/s4,5 show
storcli /cx[/eall]/sall show
This command shows the summary information for all the enclosures and physical drives connected to the controller.
Input example:
storcli /c0/eall/sall show
storcli /cx[/ex]/sx|sall show all
This command shows all information of a physical drive for the specified slot in the controller. If you use the all
option, the command shows information for all slots on the controller. x stands for a number, a list of numbers, a range
of numbers, or all numbers.
This command also shows the NCQ (Native Command Queuing) status (Enabled, Disabled, or N/A) which is
applicable only to SATA drives. If the controller to which the SATA drive is connected supports NCQ and NCQ is
enabled on the SATA drive, the status is shown as Enabled; else it is shown as Disabled. If NCQ is not a supported
drive operation on the controller, the status is shown as N/A.
Input examples:
storcli /c0/e3/s0-3 show all
storcli /c0/e35/sall show all
missing: Sets the drive status as missing.
good: Sets the drive status to unconfigured good.
offline: Sets the drive status to offline.
online: Sets the drive status to online.
all: shows all properties of the physical drive.
See
Drive Show
Commands.
NOTE
If enclosures are used to connect physical drives to the controller,
specify the enclosure ID in the command. If no enclosures are used,
you must specify the controller ID and slot ID.
Value Range
LSI Corporation
- 171 -
Working with the Storage Command Line Tool
Description
Sets physical drive properties.
Shows virtual drive information.
Chapter 6: StorCLI
Advertisement
Table of Contents
