Working With The Storage Command Line Tool; System Commands; System Show Commands - Lenovo ThinkServer RD650 User Manual

12Gb/s MegaRAID SAS Software User Guide
March 2014
Table 36 Verbs in the StorCli Command Syntax
Verbs
add
del
set
show
pause
resume
compare
download
start
flush
stop
import
expand
insert
flasherase
transform
restart
apply
<[adverb | attributes | properties] > – Specifies what the verb modifies or displays.

<[key=value]> – Specifies a value, if a value is required by the command.

6.6

Working with the Storage Command Line Tool

This section describes the commands supported by the Storage Command Line Tool.
6.6.1

System Commands

6.6.1.1

System Show Commands

The Storage Command Line Tool supports the following system show commands:
storcli show
storcli show all
storcli show ctrlcount
storcli show help
storcli -v
This verb adds virtual drives, JBODs, and so on to the object identifier.
This verb deletes a drive, value, or property of the object identifier.
This verb sets a value of the object identifier.
This verb shows the value and properties of the object identifier.
This verb pauses an ongoing operation.
This verb resumes paused operation.
This verb compares an input value with a system value.
This verb downloads and flashes a file to the target.
This verb starts an operation.
This verb flushes a controller cache or a drive cache.
This verb stops an operation that is in progress. A stopped process cannot be resumed.
This verb imports the foreign configuration into the drive.
This verb expands the size of the virtual drive.
This verb replaces the configured drive that is identified as missing, and starts an automatic rebuild.
This verb erases the flash memory on the controller.
This verb downgrades the firmware memory on the controller.
This verb restarts the controller without a system reboot.
This verb applies the activation Key to a WarpDrive card.
NOTE The Storage Command Line Tool is not case sensitive.
CAUTION The order in which you specify the command options should be the
same as in the User Guide; otherwise, the command will fail.
NOTE The Storage Command Line Tool does not support the Snapshot
feature.
Description
LSI Corporation
- 159 -
Chapter 6: StorCLI
Working with the Storage Command Line Tool