Table of Contents
Advertisement
ID-3000 WORKSTATION VER 2.4
OPERATING INSTRUCTIONS
Scanner Lamp Fails to Light
If the scanner turns on but the lamp fails to light during a
scan, the scanner lamp may be burned out. The scan-
ner must be returned to Polaroid for a lamp replace-
ment. Contact the Polaroid Resource Center (page 2)
for assistance.
Portrait Feed Problems
If portraits are skewing during the scan, check the feed
tray and the visible portion of the feed path for debris or
dirt that may be deflecting the portraits.
The scanner automatically ejects each portrait after
scanning it. If a portrait fails to eject and is not visible in
the feed tray, it may be accessible through the scanner's
bottom access door. To open this door, turn the scan-
ner on its side.
DOOR.EPS
Portrait Out of Position
When scanned portraits are consistently out of position,
the area captured by the scanner may require adjust-
ment. See Adjusting the Portrait Capture Area on page
128.
SCANNER DIAGNOSIS
PAGE 145
Advertisement
Table of Contents
