Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Note: The dimensional equivalents will
change if you change the width of the
captured area from greater than 1.4
inches to less than 1.4 inches (or vice-
versa). If you are not achieving the ex-
pected results, recheck the displayed
dimensional equivalents.
6. Press the Tab key to move the highlight on the adjust-
ment screen. Then type the dimension desired be-
tween the left edge of the photograph (or the left
edge of the carrier if a carrier is being used) and the
left edge of the captured area.
7. Press the Tab key to move the highlight on the adjust-
ment screen, then type the dimension desired for
the width of the captured area.
Note: You cannot adjust the height of the cap-
tured area directly. The system auto-
matically calculates the height based
on the width because the height-to-
width ratio must remain constant.
8. When all the desired dimensions have been entered,
press the F10 key to save the new values.
The message Insert Picture into Color Por-
trait Scanner appears.
PAGE 130
PORTRAIT SCANNER ADJUSTMENT
ID-3000 WORKSTATION VER 2.4
Advertisement
Table of Contents
