Table of Contents
Advertisement
OPERATING INSTRUCTIONS
ID-3000 WORKSTATION VER 2.4
3. Clean the film tab slot.
49UPPER.EPS
4. Reinstall the roller assembly in the film holder.
Picture Faults and Causes
PICTURE FAULTS
Repeated, evenly-spaced spots
Due to dirt on the steel developer rollers. See "Cleaning
the Developer Rollers" on page 141.
Missing corners or orange-red marks along edges
Caused by pulling the yellow tab out at an angle.
Oblong in print
The white tab was not pulled all the way out. When the
yellow tab was pulled, that white tab was pulled back
into the holder.
Many small white specks
Caused by pulling the yellow tab out too fast. This also
can cause pink lines, streaks or blotches on color prints.
Muddy-looking print
The print was separated from the negative after too
short a time (underprocessed). Underprocessed prints
are sometimes brownish pink. If prints are consistently
underprocessed, you may need to lengthen the process-
ing time. See "Adjusting the Film Timers" on page 109.
PAGE 142
PICTURE FAULTS
Advertisement
Table of Contents
