Setting Protection Levels - Siemens SINUMERIK 808D Commissioning Manual

Commissioning the prototype
7.1 Commissioning the controller
7. Record the measurement values in the COMPLETE.MPF for the corresponding axis, and
delete the check code (for the compensation point).
For example:
8. Press the "Execute" softkey. The SINUMERIK 808D enters the AUTO mode.
9. Press the <CYCLE START> key to execute COMPLETE.MPF. And the recorded
compensation values will be saved into the SINUMERIK 808D.
10. Set MD32700 = 1 ("SYSTEM" operating area > "Mach. data" > "Basic list").
11. Restart the NC ("SYSTEM" operating area > "Start-up" > NC: Standard power-up).
12. The compensation values are effective after returning to the reference point.
13. Move the axes in JOG mode, and then you can view the actual compensation value
under "SYSTEM" operating area > " Serv. displ." > "Service axes": Abs. compens. value
meas. system 1.
7.1.5.4

Setting protection levels

The SINUMERIK 808D control system has defined protection levels for user data. You can
set protection levels for the following user data:
● Tool offsets
● Zero offsets
● Setting data
● R parameters
● Part programs
● RS232 settings
● PLC projects
● Protected work areas
68
Commissioning Manual, 01/2015, 6FC5397-4EP10-0BA0
Commissioning Manual