Setting A Password - Siemens SINUMERIK 808D Commissioning Manual

Access level: No password
If you have deleted your password or do not set a password, you only have the access right
of viewing above-mentioned function areas.
Note
The system has no password by default.
4.5.2

Setting a password

The control system is delivered without a password. You must input the password of
"SUNRISE" to perform the commissioning work.
Perform the following steps to input the password:
1. In the "SYSTEM" operating area (key combination:
softkey "Set password". The message text at the bottom of the screen shows "No pass-
word set":
2. Enter "SUNRISE" and press the "Accept" softkey.
3. The message text now shows "Access level: Manufacturer", which indicates that you
have successfully set the password.
Note
You can change the default password to you by using the "Change password" softkey.
You can also delete the current password to protect your settings by pressing the "Delete
password" softkey.
After the series production, you must press the "Delete password" softkey to exit the
"Manufacturer" access level.
Commissioning Manual
Commissioning Manual, 01/2015, 6FC5397-4EP10-0BA0
Switching on and preparing for commissioning
+
4.5 Password
), press the vertical
35