Other Faults; Display Data List; A.6.2.4 Other Faults - Siemens SINUMERIK 808D Commissioning Manual

Appendix
A.6 Diagnostics
A.6.2.4

Other faults

1. Motor speed incorrect
– Description: The actual motor position is always wrong, and the motor speed is not
– Cause: The pulse signal from the NC to drive is incorrect.
– Remedy: Check the pulse signal line connection
2. Brake not open
– Description: The brake is not open when the drive is in "S-Run" state.
– Cause: A short circuit has occurred in the brake cable.
– Remedy: Check brake cable connection
A.6.2.5

Display data list

Data No. Name
D10 Torque setpoint
1)
D11 Actual value of the torque
1)
D12 Actual value of the phase cur-
1)
rent
D20 Motor speed setpoint
D21 Actual motor speed
D30 Position revolution setpoint
D31 Position angle setpoint
D32 Actual position revolutions
D33 Actual position angle
D34 Position deviation angle
D50 Digital input signal
1)
D51 Digital output signal
1)
D80 Firmware version
1)
D81 Power Board rated current
D82 Parameter version number
1)
The data type of D10, D11, D12, D80, D82 is in all decimal format. The display value for D50 and D51 respectively
1)
varies as the case requires.
104
right, either.
Data format
Decimal
(See table below)
Integer
Bit (See table below)
(See table below)
Integer
(See table below)
Unit
Nm
Nm
A
RPM
RPM
Motor revolutions
Increments (10000/r)
Motor revolutions
Increments (10000/r)
Increments (10000/r)
Bits in hex
Bits in hex
Commissioning Manual, 01/2015, 6FC5397-4EP10-0BA0
Data group
Current
Speed
Position
I/O
HW, FW
Commissioning Manual