Siemens SINUMERIK 808D Commissioning Manual page 80

Series production
8.3 Data backup
4. Press the "OK" softkey to confirm the warning information and the system restoring
begins:
5. Wait until the CNC controller restarts and the control system has been successfully
restored.
Note
Since the system restoring can delete the password, you must input your password again
when the CNC controllers restarts.
Restore the control system with the start-up archive
When restoring the control system with a start-up archive, you can follow exactly the same
procedures used to restore the prototype machine. For details, refer to the section "Restoring
the control system with the start-up archive file (Page 73)".
80
Commissioning Manual, 01/2015, 6FC5397-4EP10-0BA0
Commissioning Manual