Siemens SINUMERIK 808D Commissioning Manual page 61

Note
The value of MD36200 should be 10% higher than that of MD 32000; otherwise, alarm
025030 occurs.
Fill in weighted machine data
No.
36300
Table 7- 4
No.
35010
35110
35130
36200
31050
31060
Note
A maximum of 5 spindle gear stages can be available. Assigning the same parameters to the
index [0] and [1] can activate gear changes (1 to 5) just by setting the corresponding
interface signals via the PLC application.
Commissioning Manual
Commissioning Manual, 01/2015, 6FC5397-4EP10-0BA0
Name
ENC_FREQ_LIMIT
For spindle with selective gearbox
Name
GEAR_STEP_CHANGE_ENA
BLE
GEAR_STEP_MAX_VELO[0]
to [5]
GEAR_STEP_MAX_VELO_LI
MIT[0] to [5]
AX_VELO_LIMIT[0] to [5]
DRIVE_AX_RATIO_DENUM[0]
to [5]
DRIVE_AX_RATIO_NUMERA[
0] to [5]
7.1 Commissioning the controller
Unit Value Description
Hz 300,000 Encoder limit frequency = Motor rated
velocity/60 x Encoder resolution
Unit Value Description
- 0 Gear change active. Spindle has several
steps
- * Maximum speed for gear stage change
(gear stage number): 0 to 5
- * Maximum speed of gear stage (gear
stage number): 0 to 5
- * Threshold value for velocity monitoring
(control parameter set number): 0 to 5
- * Denominator load gearbox (control pa-
rameter number): 0 to 5
- * Numerator load gearbox (control param-
eter set): 0 to 5
Commissioning the prototype
61