User Interface - 3D Systems ProX DMP 100 User Manual

USER INTERFACE

At the start of the printer, the
from the main tool bar (1) .
The main tool bar (1) consists of :
Icon
Access button for
Access button for
Access button for
Access button for the
This button enables chamber lighting . It is always available for use
Machine off button (see section "Shutting printer down" on page 59)
Close Application button (see section "Closing / opening
NOTE: The text displayed on the
machine:
• INIT : the machine is initializing (during start-up or after an emergency shutdown),
• READY : the machine is operational,
• UNLOCK : the machine is in unlocked mode (front doors or sas door opened, or unlocked),
• RESET : the machine is reinitializing (after a STOP button, or a relock of the doors),
• MANUF : the machine is manufacturing,
• C .B . : the machine is on a cycling break, during manufacturing,
• PREPA : the machine is on a preparation cycling,
• MAINT : the machine is in maintenance mode .
3D SYSTEMS, INC.
Operator PX Control
level (of
Preparation Menu
(see section "Preparation menu" on page 34)
Manufacturing Menu
User Level Selection
Machine Status page (see section "Machine Status menu" on page 45)
Machine Status
V2) is logged by default . Only
Description
(see section "Manufacturing menu" on page 42)
(see section "User level selection" on page 45)
PX Control
access button indicates the current status of the
33
Operator
functions are available
PX Control 2 .X .X .1
application" on page 59)
PN:80-D48 REV A
1