Closing / Opening Px Control Application; Shutting Printer Down; Powering Down The Printer - 3D Systems ProX DMP 100 User Manual

CLOSING / OPENING PX CONTROL APPLICATION

1 . Click on the button (1) .
2 . Click "Yes" on the "PX Control : Closing" message.
To relaunch the PX Control application, double-click on the icon

SHUTTING PRINTER DOWN

1 . Click on the button (1) .
2 . Click "Yes" on the "PX Control : Shuttdown" message. The
complete shutdown of the machine takes about 30 seconds
(shutting down the system control) . Then push the start button to
switch off .
The shutting printer down procedure will only switch off the printer, it will not be de-energized . To de-
energize the printer, refer to the section "Powering down the printer" on page 59 .

POWERING DOWN THE PRINTER

1 . The printer must be at first switched off (see section "Shutting
printer down" on page 59) .
2 . Close the gas valve (1) and compressed air valve (2) located on
right side of the printer .
3 . Switch the locking key to position "0" .
4 . Turn off the main switch (3) .
3D SYSTEMS, INC.
"PX_Control", from the desktop.
1 2
3
59
PX Control 2 .X .X .1
PX Control 2 .X .X .1
PN:80-D48 REV A
1
1