Table of Contents
Advertisement
14 . Clean the sintering piston head with the paper towel (4) .
15 . Place the sintering plate on the sintering piston (5), and fix it by tightening
crosswise the M5x12 screws .
Make sure to position the sintering plate so that the grinding
lines are on the same direction than the operator (i .e parallel
to the carriage) .
16 . Put the hex key wrench and towels on the airlock .
17 . Close the glove doors and remove hands from the gloves .
18 . Rotate the airlock to OPEN position .
19 . Open the airlock door and empty it .
20 . Close the airlock door .
21 . Close the front doors .
Zero sintering search
Operations described below complement and follow on from the Preparation Assistant "Step 4 : Zero sintering" on page
36 .
The zero research is performed with the roller . Please ensure :
The sintering plate must be clean . No dust must be located on its surface . The roller should not get in
touch with any powder during this cycle . Make sure to keep a clean area as described on the section
"Unloading a plate" on page 55 .
1 .
Check the sintering plate is clean .
2 .
Start the
Zero sintering
3 .
The zero sintering value will then be displayed .
3D SYSTEMS, INC.
cycle on the control panel (see "Step 4 : Zero sintering" on page 36) .
Grinding lines
Fixing screw
49
4
5
PN:80-D48 REV A
Advertisement
Table of Contents
