3D Systems ProX DMP 100 User Manual page 57

10 . Use a lamp to observe the lens in order to check for any traces of dirt (5) .
11 . Repeat these steps until the lens is clean .
Caution: comply with the following steps in order to ensure the correct positioning of the head after
opening .
12 . Make sure the mechanical stop is clean (6) .
13 . Make sure the head-lens support contact is clean (7) .
14 . Ensure the cleanliness of the bellows and the lens cleaner diffuser (8) .
15 . Close the head-lens assembly, making sure that the mechanical stop is in localized contact with the head-lens support
(9) .
16 . Tighten the assembly (9) .
Excessive tightening could damage the localized contact .
3D SYSTEMS, INC.
Mechanical stop
Head-lens support
Bellows
Diffuser
Head-lens support
Mechanical stop
Tighten clamp
53
5
6
7
8
9
PN:80-D48 REV A