Table of Contents
Advertisement
Manufacturing chamber cleaning
The aims of these following steps are to brush the unsintered powder into the collecting cans, and to get a manufacturing
chamber as clean as possible, as per the following figure:
Always scoop slowly from as close as possible to the surface to avoid producing dust from material .
1 .
With a brush, clean the zone between the feeding piston and the sintering piston (1) so that the roller does not get dirty
when searching the zero of the sintering plate at the next manufacturing run .
2 .
Clean the sintering piston and area around it .
3 .
Remove powder from the carriage (3) .
4 .
Move the carriage up to the sintering piston, then clean the left side of the
manufacturing chamber (4), sweeping the powder toward the collecting cans .
5 .
When left side cleaning complete, move back the carriage to the left (position 0) .
6 .
Clean the whole chamber, in front and behind the pistons (5) . Brush the unsintered powder into the collecting cans .
Make sure not to put powder behind the protection bellow (6) .
3D SYSTEMS, INC.
5
1
5
6
2
3
4
Areas to clean
57
PN:80-D48 REV A
Advertisement
Table of Contents
