Table of Contents
Advertisement
6 .
Clean the sides of the covers with the use of a damp cotton cloth to neutralize any presence of the condensate (black
particle aspect) .
7 .
Clean inside of the enclosures with the use of a damp cotton cloth to neutralize any presence of the condensate (black
particle aspect) .
8 .
Then, remove any presence of powder with the use of a vacuum cleaner and a natural fiber brush. Depending on the
grain size of the material, some powder may be present on the "cleaning areas", preventing the printer from operating
properly .
9 .
Finalize the cleaning with a damp cotton cloth .
10 . Put back the cover panels and secure them by tightening the screws .
The next steps are performed to clean the back casings .
11 . Open the rear doors of the printer .
12 . Remove the cover panel (3) at the rear of the main cabinet, as indicated on the figure.
Caution: injury risk . The cover panel is heavy (25 kg) .
To facilitate the cover panel removal, replace at first the 2x M5 screws located
on the upper-right corner and upper-left corner (circled in blue on the adjacent
figure) with M5x25 set screws. They will support the panel during the other
screws removal .
WARNING: FIRE AND EXPLOSION HAZARDS .
COMBUSTIBLE DUST INSIDE . METAL POWDERS ARE FLAMMABLE AND POTENTIALLY EXPLOSIVE,
ESPECIALLY WHEN DISPERSED IN A CLOUD AND EXPOSED TO AN IGNITION SOURCE SUCH AS HEAT OR
STATIC ELECTRICITY SPARK . OPERATORS AND SERVICE PERSONAL SHOULD AVOID DISTURBING POWDER
MANIPULATE CAREFULLY TO AVOID AS MUCH AS POSSIBLE SUSPENDING OF FINE PARTICLES) .
WARNING : FIRE AND EXPLOSION HAZARDS . PRESENCE OF METAL PARTICLE CONDENSATE . HIGHLY
COMBUSTIBLE . DO NOT VACUUM, DO NOT BLOW . USE DAMP COTTON CLOTH TO REMOVE THE METAL
PARTICLE CONDENSATE .
WARNING : STATIC HAZARD . METAL PARTICLE CONDENSATES INSIDE THE PRINTER ARE HIGHLY
COMBUSTIBLE AND SHOULD BE KEPT AWAY FROM SOURCES OF POTENTIAL IGNITION . WEAR ANTI-STATIC
CLOTHING, ANTI-STATIC SAFETY SHOES, STAND ON GROUNDED ANTI-STATIC FLOOR PAD .
3D SYSTEMS, INC.
Cleaning areas
72
3
PN:80-D48 REV A
Advertisement
Table of Contents
