Table of Contents
Advertisement
9 .
Using the brush, remove powder between the 2 pistons, and clean the
sintering plate by sweeping any unsintered powder from the left to the
right (1) towards the collecting cans .
Always scoop slowly from as close as possible to the surface to
avoid producing dust from material .
10 . Put the brush on the airlock .
11 . Close the glove doors and remove hands from the printer .
12 . Close the front doors .
13 . Move up the sintering piston by about 30 mm .
14 . Open the front doors of the machine .
15 . Repeat steps from 8 to 14 to continue remove the excess of powder, until the sintering plate reaches its top position .
16 . When sintering in top position, remove the sintering plate by unscrewing
the 4xM5 screws with the use of the hex key wrench (2) .
Place each screw on the airlock when removed .
17 . Put the sintering plate and the key wrench on the airlock .
18 . Close the glove doors and remove hands from the printer .
19 . Rotate the airlock in OPEN position .
20 . Open the airlock door .
21 . Remove the sintering plate .
22 . Close the airlock door .
23 . Proceed to the next section .
3D SYSTEMS, INC.
1
2
56
PN:80-D48 REV A
Advertisement
Table of Contents
