Table of Contents
Advertisement
2 .
During the automatic cycle, the user is prompted to indicate if a standard 10mm plate is
used (2):
•
If yes, click "Yes" . Then the automatic actions will continue . When completed, click on
(4) to go to the next step .
•
If a different 10mm plate is used, then select "No", and proceed the following step .
3 .
Position the sintering plate by using the window (3) (with the arrows, or by entering a
setpoint), so that the top of the sintering plate is leveled with the sleeve of the sintering
piston. Then confirm by clicking on Validate . The automatic cycle will then continue .
4 .
When the automatic cycle is completed, the zero sintering value is displayed (4) . Click on
Next
(5) to go to the next step .
Step 5 : Powder loading
The
Powder loading
step is performed manually:
1 .
Perform the actions (1) by using the available
commands (2) and the external control panel .
Consult the section "Loading the feeding piston"
on page 50 for details .
2 .
When manual actions completed, click on
to go to the next step .
Step 6 : Powder bed
Powder bed
The
step will allow to create the powder bed: the first powder layer will be deposited on the sintering plate.
1 .
Enter the iteration number of the powder bed
sequence, by using the "-" and "+" buttons (1).
2 .
Click on the
Start
button (2): this will launch the
automatic cycle .
3 .
Consult the section "Creating the powder bed" on
page 51 for details on how to control the well
completion of the power bed .
4 .
When cycle completed, click on
the next step .
3D SYSTEMS, INC.
Next
(3)
Next
(3) to go to
37
Next
2
3
2
3
1
2
3
PN:80-D48 REV A
1
Advertisement
Table of Contents
