User Maintenance; Preventive Maintenance; Overview Table - 3D Systems DMP Flex 350 User Manual

6 USER MAINTENANCE
6.1 Preventive Maintenance
6.1.1 Overview Table
6.2 Before every print job
6.4 Every 3 months
6.5 Every 1600 job hours
6.6 Every 6 months /
WARNING: WHEN PERFORMING THE OPERATIONS DESCRIBED BELOW, FOLLOW ALL SAFETY PRECAUTIONS AS
SPECIFIED IN THE DMP FLEX 350 USER GUIDE (P/N: 15-D100) AND THE DMP SAFETY GUIDE (80-D0712).
3D Systems, Inc.
FREQUENCY
6.3 Monthly
2000 job hours
TASK
6.2.1 Clean Machine Interior and Printer Module
6.2.2 Clean Laser Window
6.3.1 Check Pressure Levels
6.3.2 Check Emergency Off Buttons
6.3.3 Check Chiller Temperature and Water Level
6.3.4 Clean Chiller Air vent
6.3.5 Check Printer Gloves (Option)
6.3.6 Perform Automatic Laser Power Calibration
6.4.1 Replace Chiller Fluid and Check Water Quality
6.4.2 Clean Machine Exterior
6.4.3 Check Blower Oil Level
6.4.4 Check Vacuum Pump Oil Level
6.5.1 Replace Process Filter
6.5.2 Clean Overpressure Valve
6.5.3 Clean Vacuum Pump Ventilator
81 p/n: 15-D100, rev. D