3D Systems ProX DMP 100 User Manual page 40

3d production printer

Hide thumbs Also See for ProX DMP 100:

Table of Contents

Step 3 : Plate loading

The

Plate loading

step includes both automatic and manual actions . When automatic actions done, manual actions is

required .

1 .

Click on the

Start

button (1) .

2 .

Enter a plate number that will be used to identify the plate (2) . After validating the plate number, the automatic cycle

will be launched .

NOTE: the pre-filled number is the first number plate available. This

number will correspond to the sintering plate being loaded on the

printer .

3 .

Perform the actions (3) by using the available commands (4) and the external control panel . Consult the section

"Sintering plate preparation and loading" on page 48 for details .

4 .

When manual actions completed, click on

Step 4 : Zero sintering

The

Zero sintering

step will allow the printer to perform a zero sintering . Consult the section "Zero sintering search" on

page 49 for details . This step is performed automatically:

1 .

Click on the

Start

button (1): this will launch the

automatic cycle .

3D SYSTEMS, INC.

(5) to go to the next step .

PN:80-D48 REV A

Table of Contents