Table 13-17 Ip-Over-Clns Tunnel Ios Commands; Ip-Over-Clns Tunnel Scenario 1: Ons Node To Other Vendor Gne - Cisco ONS 15454 Reference Manual

Chapter 13 Management Network Connectivity
Table 13-17
Step Step
1
2
3
If you are provisioning an IP-over-CLNS tunnel on a Cisco router, always follow procedures provided
in the Cisco IOS documentation for the router you are provisioning. For information about ISO CLNS
provisioning including IP-over-CLNS tunnels, see the "Configuring ISO CLNS" chapter in the
Cisco IOS Apollo Domain, Banyon VINES, DECnet, ISO CLNS, and XNS Configuration Guide.

13.7.8.2 IP-over-CLNS Tunnel Scenario 1: ONS Node to Other Vendor GNE

Figure 13-28
other vendor NE has an IP connection to an IP DCN to which a CTC computer is attached. An OSI-only
(LAP-D) SDCC and a GRE tunnel are created between the ONS NE 1 to the other vender GNE.
ONS NE 1 IP-over-CLNS tunnel provisioning information:
•
•
•
•
•
Other vender GNE IP-over-CLNS tunnel provisioning information:
•
•
•
•
•
OL-9217-01
IP-over-CLNS Tunnel IOS Commands
Router (config) # interface ctunnel
interface-number
Router (config-if # ctunnel destination
remote-nsap-address
Router (config-if) # ip address
ip-address mask
shows an IP-over-CLNS tunnel created from an ONS node to another vendor GNE. The
Destination: 10.10.10.100 (CTC 1)
Mask: 255.255.255.255 for host route (CTC 1 only), or 255.255.255.0 for subnet route (all CTC
computers residing on the 10.10.10.0 subnet)
NSAP: 39.840F.80.1111.0000.1111.1111.cccccccccccc.00 (other vendor GNE)
Metric: 110
Tunnel Type: GRE
Destination: 10.20.30.30 (ONS NE 1)
Mask: 255.255.255.255 for host route (ONS NE 1 only), or 255.255.255.0 for subnet route (all ONS
nodes residing on the 10.30.30.0 subnet)
NSAP: 39.840F.80.1111.0000.1111.1111.dddddddddddd.00 (ONS NE 1)
Metric: 110
Tunnel Type: GRE
13.7 13.7.8 IP-over-CLNS Tunnels
Purpose
Creates a virtual interface to transport IP over a
CLNS tunnel and enters interface configuration
mode. The interface number must be unique for each
CTunnel interface.
Configures the destination parameter for the
CTunnel. Specifies the destination NSAP1 address of
the CTunnel, where the IP packets are extracted.
Sets the primary or secondary IP address for an
interface.
Cisco ONS 15454 Reference Manual, R7.0.1
13-47