Node View - Cisco ONS 15454 Reference Manual

Chapter 8 Cisco Transport Controller Operation
Table 8-5
Card Status
Sby
Act
NP
Ldg
Mis
The port color in both card and node view indicates the port service state.
and their service states. For more information about port service states, see
and Service States."
Table 8-6
Port Color
Blue
Blue
Gray
OL-9217-01
Node View Card Statuses
Description
Card is in standby mode.
Card is active.
Card is not present.
Card is resetting.
Card is mismatched.
Node View Card Port Colors and Service States
Service State Description
OOS-MA,LPBK (Out-of-Service and Management, Loopback) Port is in a
loopback state. On the card in node view, a line between
ports indicates that the port is in terminal or facility
loopback (see
page
suppressed. Raised fault conditions, whether or not their
alarms are reported, can be retrieved on the CTC
Conditions tab or by using the TL1 RTRV-COND
command.
OOS-MA,MT (Out-of-Service and Management, Maintenance) Port is
out-of-service for maintenance. Traffic is carried and
loopbacks are allowed. Alarm reporting is suppressed.
Raised fault conditions, whether or not their alarms are
reported, can be retrieved on the CTC Conditions tab or by
using the TL1 RTRV-COND command. Use OOS-MA,MT
for testing or to suppress alarms temporarily. Change the
state to IS-NR, OOS-MA,DSBLD, or OOS-AU,AINS
when testing is complete.
OOS-MA,DSBLD (Out-of-Service and Management, Disabled) The port is
out-of-service and unable to carry traffic. Loopbacks are
not allowed in this service state.
Figure 8-4 on page 8-10
8-10). Traffic is carried and alarm reporting is
Cisco ONS 15454 Reference Manual, R7.0.1

8.5 8.5.1 Node View

Table 8-6 lists the port colors
Appendix B, "Administrative
and Figure 8-5 on
8-9