Ubic-V Eia; Figure 1-20 Ubic-V Slot Designations - Cisco ONS 15454 Reference Manual

1.5 1.5.8 UBIC-V EIA

1.5.8 UBIC-V EIA
UBIC-V EIAs are attached to the shelf assembly backplane to provide up to 112 transmit and receive
connections through 16 SCSI connectors per side (A and B). The UBIC-V EIAs are designed to support
DS-1, DS-3, and EC-1 signals. The appropriate cable assembly is required depending on the type of
signal.
You can install UBIC-Vs on one or both sides of the ONS 15454. As you face the rear of the ONS 15454
shelf assembly, the right side is the A side (15454-EIA-UBICV-A) and the left side is the B side
(15454-EIA-UBICV-B). The diagrams adjacent to each row of SCSI connectors indicate the slots and
ports that correspond with each SCSI connector in that row, depending on whether you are using a
high-density (HD) or low-density (LD) configuration.
UBIC-V EIAs will support high-density electrical cards (DS3/EC1-48, DS1/E1-56), as well as
low-density electrical cards.
Figure 1-20
Figure 1-20 UBIC-V Slot Designations
JACKSCREW SHOULD BE
B
INSTALLED FIRST AND
REMOVED LAST
(SLOT 17)(SLOT 16)(SLOT 15)
DS1/DS3
P
TX
LD
P
RX
HD(SLOT 17) HD(SLOT 16)
J17 J20 J21 J23
REAR COVER
Rx
BRACKET
LOCATION
HD(SLOT 17) HD(SLOT 16)
J25 J28 J29 J31
HD(SLOT 16) HD(SLOT 17)
J24 J22 J19 J18
Rx
HD(SLOT 16) HD(SLOT 17)
J32 J30 J27 J26
(SLOT 14)(SLOT 13)(SLOT 12)
TX
LD
RX
REAR COVER
BRACKET
LOCATION
Cisco ONS 15454 Reference Manual, R7.0.1
1-32
shows the A- and B-side slot assignments.
Tx
JACKSCREW SHOULD BE
INSTALLED FIRST AND
REMOVED LAST
Tx
JACKSCREW SHOULD BE
INSTALLED FIRST AND
REMOVED LAST
Chapter 1
DS1/DS3
Tx
Tx
Shelf and Backplane Hardware
JACKSCREW SHOULD BE
A
INSTALLED FIRST AND
REMOVED LAST
(SLOT 3) (SLOT 2) (SLOT 1)
P
TX
LD
P
RX
HD(SLOT 2) HD(SLOT 1)
J7 J5 J4 J1
REAR COVER
BRACKET
LOCATION
Rx
HD(SLOT 2) HD(SLOT 1)
J15 J13 J12 J9
HD(SLOT 1) HD(SLOT 2)
J2 J3 J6 J8
Rx
HD(SLOT 1) HD(SLOT 2)
J10 J11 J14 J16
(SLOT 6) (SLOT 5) (SLOT 4)
TX
LD
RX
REAR COVER
BRACKET
LOCATION
OL-9217-01