Slot Compatibility - Cisco ONS 15454 Reference Manual

5.7 5.6.4 Slot Compatibility

Table 5-12
Port-Level LED Status
Off
Steady amber
Solid green
Flashing green
5.6.4 Slot Compatibility
The G1000-4 card requires Cisco ONS 15454 Release 3.2 or later system software and the XC10G
cross-connect card. You can install the card in Slots 1 to 6 and 12 to 17, for a total shelf capacity of
48 Gigabit Ethernet ports. The practical G1000-4 port per shelf limit is 40, because at least two slots are
typically filled by OC-N trunk cards such as the OC-192.
5.7 G1K-4 Card
Note For hardware specifications, see the
The G1K-4 card is the functional equivalent of the earlier G1000-4 card and provides four ports of
IEEE-compliant, 1000-Mbps interfaces. Each interface supports full-duplex operation for a maximum
bandwidth of 1 Gbps or 2 Gbps bidirectional per port, and 2.5 Gbps or 5 Gbps bidirectional per card.
Each port autonegotiates for full duplex and IEEE 802.3x flow control. The G1K-4 card uses GBIC
modular receptacles for the optical interfaces. For details, see the
section on page
Figure 5-6 shows the card faceplate and the block diagram of the card.
Cisco ONS 15454 Reference Manual, R7.0.1
5-16
G1000-4 Port-Level Indicators
Description
No link exists to the Ethernet port.
A link exists to the Ethernet port, but traffic flow is inhibited. For example,
an unconfigured circuit, an error on line, or a nonenabled port might inhibit
traffic flow.
A link exists to the Ethernet port, but no traffic is carried on the port.
A link exists to the Ethernet port, and traffic is carried on the port. The LED
flash rate reflects the traffic rate for the port.
"A.7.7 G1K-4 Card Specifications" section on page
5-31.
Chapter 5 Ethernet Cards
A-47.
"5.13 Ethernet Card GBICs and SFPs"
OL-9217-01