Oc12 Lr/Stm4 Lh 1550 Card-Level Indicators - Cisco ONS 15454 Reference Manual

Chapter 4 Optical Cards
Table 4-7
Card-Level Indicators
Red FAIL LED
Green/Amber ACT
LED
Amber SF LED
4.6.2 OC12 LR/STM4 LH 1550 Port-Level Indicators
You can find the status of the OC12 LR/STM4 LH 1550 card port by using the LCD screen on the
ONS 15454 fan-tray assembly. Use the LCD to view the status of any port or card slot; the screen
displays the number and severity of alarms for a given port or slot.
4.7 OC12 IR/STM4 SH 1310-4 Card
For hardware specifications, see the
Note
page
The OC12 IR/STM4 SH 1310-4 card provides four intermediate or short range SONET/SDH
OC-12/STM-4 ports compliant with the ITU-T G.707, ITU-T G.957, and Telcordia GR-253-CORE.
Each port operates at 622.08 Mbps over a single-mode fiber span. The card supports VT,
nonconcatenated (STS-1), or concatenated (STS-1, STS-3c, STS-6c, or STS-12c) payloads.
Warning The laser is on when the optical card is booted. The port does not have to be in service for the laser
to be on.
Figure 4-6
OL-9217-01

OC12 LR/STM4 LH 1550 Card-Level Indicators

Description
The red FAIL LED indicates that the card's processor is not ready. Replace
the card if the red FAIL LED persists.
The green ACT LED indicates that the card is operational and ready to carry
traffic. The amber ACT LED indicates that the card is part of an active ring
switch (BLSR).
The amber SF LED indicates a signal failure or condition such as LOS, LOF,
AIS-L, or high BERs on the card's port. The amber SF LED is also on if the
transmit and receive fibers are incorrectly connected. If the fibers are
properly connected, the light turns off.
A-31. See Table 4-2 on page 4-4
shows the OC12 IR/STM4 SH 1310-4 faceplate and a block diagram of the card.
4.7 4.6.2 OC12 LR/STM4 LH 1550 Port-Level Indicators
"A.6.6 OC12 IR/STM4 SH 1310-4 Specifications" section on
for optical card compatibility.
Cisco ONS 15454 Reference Manual, R7.0.1
4-15