Ml100X-8 Card-Level Indicators - Cisco ONS 15454 Reference Manual

Chapter 5 Ethernet Cards

5.9.1 ML100X-8 Card-Level Indicators

The ML100X-8 card supports two card-level LED indicators.
indicators.
Table 5-17
Card-Level LEDs
FAIL LED (Red)
ACT LED (Green)
5.9.2 ML100X-8 Port-Level Indicators
The ML100X-8 card provides a pair of LEDs for each Fast Ethernet port: an amber LED for activity
(ACT) and a green LED for LINK.
Table 5-18
Port-Level Indicators
ACT LED (Amber)
LINK LED (Green)
Both ACT and LINK LED
5.9.3 Cross-Connect and Slot Compatibility
The ML100X-8 card operates in Slots 1 to 6 or 12 to 17 with the XC10G or XC-VXC-10G cards. It
operates only in Slots 5, 6, 12, or 13 with the XCVT card.
5.10 ML1000-2 Card
For hardware specifications, see the
Note
The ML1000-2 card provides two ports of IEEE-compliant, 1000-Mbps interfaces. Each interface
supports full-duplex operation for a maximum bandwidth of 2 Gbps per port and 4 Gbps per card. Each
port autoconfigures for full duplex and IEEE 802.3x flow control.
OL-9217-01
ML100X-8 Card-Level Indicators
Description
The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the ML100-FX card. As part of the
boot sequence, the FAIL LED is turned on until the software deems the card
operational.
The green ACT LED provides the operational status of the ML100-FX. If the
ACT LED is green, it indicates that the ML100-FX card is active and the
software is operational.
Table 5-18
ML100X-8 Port-Level Indicators
Description
A steady amber LED indicates a link is detected, but there is an issue
inhibiting traffic. A blinking amber LED means traffic is flowing.
A steady green LED indicates that a link is detected, but there is no
traffic. A blinking green LED flashes at a rate proportional to the level
of traffic being received and transmitted over the port.
Unlit green and amber LEDs indicate no traffic.
"A.7.9 ML1000-2 Card Specifications" section on page
5.10 5.9.1 ML100X-8 Card-Level Indicators
Table 5-17
describes the port-level indicators.
Cisco ONS 15454 Reference Manual, R7.0.1
describes the card-level
A-48.
5-23