Rolls Window - Cisco ONS 15454 Reference Manual

Chapter 11 Circuits and Tunnels
released. You can use the bridge and roll feature for maintenance functions such as card or facility
replacement, or for load balancing. You can perform a bridge and roll on the following ONS platforms:
ONS 15454, ONS 15454 SDH, ONS 15600, ONS 15327, and ONS 15310-CL.

11.18.1 Rolls Window

The Rolls window lists information about a rolled circuit before the roll process is complete. You can
access the Rolls window by clicking the Circuits > Rolls tabs in either network or node view.
Figure 11-16
Figure 11-16
The Rolls window information includes:
•
•
•
•
•
OL-9217-01
shows the Rolls window.
Rolls Window
Roll From Circuit—The circuit that has connections that will no longer be used when the roll
process is complete.
Roll To Circuit—The circuit that will carry the traffic after the roll process is complete. The
Roll To Circuit is the same as the Roll From Circuit if a single circuit is involved in a roll.
Roll State—The roll status; see the
Roll Valid Signal—If the Roll Valid Signal status is true, a valid signal was found on the new port.
If the Roll Valid Signal status is false, a valid signal was not found. It is not possible to get a
Roll Valid Signal status of true for a one-way destination roll.
Roll Mode—The mode indicates whether the roll is automatic or manual.
"11.18.2 Roll Status" section on page
Cisco ONS 15454 Reference Manual, R7.0.1
11.18 11.18.1 Rolls Window
11-38.
11-37