Smb Eia - Cisco ONS 15454 Reference Manual

Hide thumbs Also See for ONS 15454:

Table of Contents

Shelf and Backplane Hardware

This tool can be obtained with P/N 227-T1000 from:

This tool can be obtained with P/N RT-1L from:

1.5.6 SMB EIA

The ONS 15454 SMB EIA supports AMP 415484-1 75-ohm 4-leg connectors. Right-angle mating

connectors for the connecting cable are AMP 415484-2 (75-ohm) connectors. Use RG-179/U cable to

connect to the ONS 15454 EIA. Cisco recommends these cables for connection to a patch panel; they

are not designed for long runs. Range does not affect loopback testing.

You can use SMB EIAs with DS-1, DS-3 (including the DS3XM-6 and DS3XM-12), and EC-1 cards. If

you use DS-1 cards, use the DS-1 electrical interface adapter (balun) to terminate the twisted pair DS-1

cable to the SMB EIA (see the

support 14 ports per slot when used with a DS-1 card, 12 ports per slot when used with a DS-3 or EC-1

card, and 6 ports per slot when used with a DS3XM-6 card.

locations for the EIA. The SMB connectors on the EIA are AMP 415504-3 (75-ohm) 4-leg connectors.

To install SMB connectors, refer to the "Install Shelf and Backplane Cable" chapter in the Cisco ONS

15454 Procedure Guide.

MiniBNC Insertion and Removal Tool

Amphenol USA (www.amphenol.com)

One Kennedy Drive

Danbury, CT 06810

Phone: 203 743-9272 Fax: 203 796-2032

Trompeter Electronics Inc. (www.trompeter.com)

31186 La Baya Drive

Westlake Village, CA 91362-4047

Phone: 800 982-2629 Fax: 818 706-1040

shows the ONS 15454 with preinstalled SMB EIAs and the sheet metal cover and screw

"1.7.2 Electrical Interface Adapters" section on page

Cisco ONS 15454 Reference Manual, R7.0.1

1.5 1.5.6 SMB EIA

1-38). SMB EIAs