Tcc2 Card - Cisco ONS 15454 Reference Manual

2.2 2.2 TCC2 Card

Table 2-6
Ethernet Cards XCVT Card
ML100X-8
CE-100T-8
CE-1000-4
1. Requires a 15454-SA-ANSI or 15454-SA-HD shelf assembly.
Table 2-7
card software compatibility, see the
Table 2-7
SAN Cards
FC_MR-4
1. Requires SA-ANSI or SA-HD shelf assembly
2.2 TCC2 Card
For hardware specifications, see the
Note
The TCC2 card performs system initialization, provisioning, alarm reporting, maintenance, diagnostics,
IP address detection/resolution, SONET section overhead (SOH) DCC/GCC termination, and system
fault detection for the ONS 15454. The TCC2 also ensures that the system maintains Stratum 3
(Telcordia GR-253-CORE) timing requirements. It monitors the supply voltage of the system.
The TCC2 card requires Software Release 4.0.0 or later.
Note
The LAN interface of the TCC2 card meets the standard Ethernet specifications by supporting a cable
Note
length of 328 ft (100 m) at temperatures from 32 to 149 degrees Fahrenheit (0 to 65 degrees Celsius).
The interfaces can operate with a cable length of 32.8 ft (10 m) maximum at temperatures from –40 to
32 degrees Fahrenheit (–40 to 0 degrees Celsius).
Figure 2-1
Cisco ONS 15454 Reference Manual, R7.0.1
2-6
Ethernet Card Cross-Connect Compatibility (continued)
Yes, in Slots 5, 6, 12, 13
Yes
Yes
lists the cross-connect card compatibility for each storage area network (SAN) card. For SAN
SAN Card Cross-Connect Compatibility
XCVT Card
Yes
shows the faceplate and block diagram for the TCC2 card.
1
XC10G Card XC-VXC-10G Card
Yes Yes
Yes Yes
Yes Yes
"6.1.3 FC_MR-4 Compatibility" section on page
1
XC10G Card XC-VXC-10G Card
Yes Yes
"A.4.1 TCC2 Card Specifications" section on page
Chapter 2 Common Control Cards
1
6-4.
1
A-10.
OL-9217-01