Clear Records; Set Date And Time - GE C70 Instruction Manual

7.1 COMMANDS

PATH: COMMANDS VIRTUAL INPUTS
 COMMANDS
 VIRTUAL INPUTS
The states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. The
second line indicates the current or selected status of the virtual input. This status will be a state off (logic 0) or on (logic 1).

PATH: COMMANDS
 COMMANDS
 CLEAR RECORDS
7
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a com-
mand setting to "Yes" and pressing the ENTER key. After clearing data, the command setting automatically reverts to "No".

PATH: COMMANDS
 COMMANDS
 SET DATE AND TIME
The date and time can be entered on the faceplate keypad. The time setting is based on the 24-hour clock. The complete
date, as a minimum, must be entered to allow execution of this command. The new time and date take effect when the
ENTER key is pressed.
When the relay is synchronizing to an external time source such as PTP, IRIG-B, or SNTP, the manually entered time is
over-written.
The timescale of the entered time is local time, including daylight savings time where and when applicable.
7-6
Virt Ip
Off
Virt Ip
Off
Virt Ip 64
MESSAGE
Off

CLEAR RECORDS

CLEAR USER FAULT
REPORTS? No
CLEAR EVENT RECORDS?
No
CLEAR OSCILLOGRAPHY?
No
CLEAR DATA LOGGER?
No
CLEAR UNAUTHORIZED
ACCESS? No
CLEAR DIRECT I/O
COUNTERS? No
CLEAR ALL RELAY
RECORDS? No

SET DATE AND TIME

SET DATE AND TIME:
2000/01/14 13:47:03
C70 Capacitor Bank Protection and Control System
Range: Off, On
1
Range: Off, On
2
↓
Range: Off, On
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes. Valid only for units with Direct Input/
Output module.
Range: No, Yes
(YYYY/MM/DD HH:MM:SS)
7 COMMANDS AND TARGETS
7.1.3 VIRTUAL INPUTS
7.1.4 CLEAR RECORDS
7.1.5 SET DATE AND TIME
GE Multilin