GE C70 Instruction Manual page 178

5.2 PRODUCT SETUP
The breaker configuration settings are shown below. Changes to these values take effect when the UR is restarted:

PATH: SETTINGS PRODUCT SETUP
 XCBR
 CONFIGURATION
5
The XCBR1 ST.LOC OPERAND setting is used to inhibit 61850 control commands to close or open breaker through UR
Breaker Control element. See the Breaker Control element logic diagram for more information.
The CLEAR XCBR1 OpCnt setting allows clearing the breaker operating counter. As breakers operate by opening and
closing, the XCBR operating counter status attribute (OpCnt) increments with every operation. Frequent breaker operation
can result in very large OpCnt values over time. This setting allows the OpCnt to be reset to "0" for XCBR1.
5-54

COMMUNICATIONS
XCBR1 ST.LOC OPERAND
Off
XCBR6 ST.LOC OPERAND
MESSAGE
Off
CLEAR XCBR1 OpCnt:
MESSAGE
No
CLEAR XCBR6 OpCnt:
MESSAGE
No
XCBR1 SYNCCHECK CLS:
MESSAGE
Off
XCBR6 SYNCCHECK CLS:
MESSAGE
Off
XCBR1 INTERLOCK OPN:
MESSAGE
Off
XCBR6 INTERLOCK OPN:
MESSAGE
Off
XCBR1 INTERLOCK CLS:
MESSAGE
Off
XCBR6 INTERLOCK CLS:
MESSAGE
Off
XCBR1 Pos ctlModel:
MESSAGE
2
XCBR6 Pos ctlModel:
MESSAGE
2
XCBR1 Pos
MESSAGE
sboTimeout: 30 s
XCBR6 Pos
MESSAGE
sboTimeout: 30 s
C70 Capacitor Bank Protection and Control System
 
IEC 61850 PROTOCOL
Range: FlexLogic operand
↓
Range: FlexLogic operand
Range: No, Yes
↓
Range: No, Yes
Range: FlexLogic operand
↓
Range: FlexLogic operand
Range: FlexLogic operand
↓
Range: FlexLogic operand
Range: FlexLogic operand
↓
Range: FlexLogic operand
Range: 0 to 4 (as per IEC 61850-7-3, ctlModel)
↓
Range: 0 to 4 (as per IEC 61850-7-3, ctlModel)
Range: 2 to 60 seconds
↓
Range: 2 to 60 seconds
5 SETTINGS
XCBR CONFIGURATION
GE Multilin