GE C70 Instruction Manual page 692

H.1 CHANGE NOTES
Table H–3: MAJOR UPDATES FOR C70 MANUAL REVISION AA3 (Sheet 2 of 2)
PAGE PAGE CHANGE
(AA2) (AA3)
5-120 5-120 Update
A- A- Update
B- B- Update
Table H–4: MAJOR UPDATES FOR C70 MANUAL REVISION AA2
PAGE PAGE CHANGE
(AA1) (AA2)
--- --- Update
--- --- Update
5-23 5-23 Add
5-31 5-31 Add
5-56 5-56 Delete
B- B- Update
H-6 H-6 Update
Table H–5: MAJOR UPDATES FOR C70 MANUAL REVISION AA1
PAGE PAGE CHANGE
(Z1) (AA1)
--- --- Add
2- 2- Update
2- 2- Update
8- --- Delete
--- 10- Add
--- D- Add
Table H–6: MAJOR UPDATES FOR C70 MANUAL REVISION Z1
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
H
--- --- Add
1-1 1-1 Add
1-5 1-5 Update
2-10 2-10 Update
5-24 5-24 Add
5-87 5-87 Update
5-91 5-91 Update
5-228 5-228 Add
H-2
DESCRIPTION
Updated FlexLogic operands table
Updated FlexAnalog and FlexInteger tables
Updated Modbus memory map and F codes
DESCRIPTION
General revision throughout document
Updated references to digital inputs/outputs to contact inputs/outputs for consistency
Added Syslog Format section
Added Far-End Fault Indication (FEFI) section
Deleted Ethernet Global Data (EGD) settings, which do not apply to the C70
Updated Modbus memory map and F codes
Updated product warranty from 24 months to 10 years
DESCRIPTION
Added content for IEC 60870-5-103 throughout document
Updated order codes
Updated specifications
Deleted chapter 8 on security, moving content to other chapters
Added Maintenance chapter, moving content from other chapters and adding new instructions to
replace the battery
Added new appendix on IEC 60870-5-103 interoperability
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-24 and 5-25 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-26 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
C70 Capacitor Bank Protection and Control System
APPENDIX H
GE Multilin