GE C70 Instruction Manual page 141

5 SETTINGS
General Security Settings
SETTING NAME DESCRIPTION
Session Lockout Number of failed authentications before the
device blocks subsequent authentication
attempts for the lockout period
Session Lockout The period in minutes that a user is prevented
Period from logging in after being locked out
Syslog Server IP The IP address of the target Syslog server to
Address which all security events are transmitted
Syslog Server Port The UDP port number of the target syslog server
Number to which all security events are transmitted
Device When enabled, local device authentication with
Authentication roles is allowed. When disabled, the UR only
authenticates to the AAA server (RADIUS).
NOTE: Administrator and Supervisor (if still
enabled) remain active even after device
authentication is disabled. The only permission
for local Administrator is to re-enable device
authentication when device authentication is
disabled. To re-enable device authentication, the
Supervisor unlocks the device for setting
changes, and then the Administrator can re-
enable device authentication.
Firmware Locked Indicates if the device receives firmware
upgrades. If Yes and the firmware upgrade
attempt is made, the device denies the upgrade
and displays an error message that the lock is
set. On each firmware upgrade, this setting goes
back to the default.
Factory Service When enabled (checkbox selected), the device
Mode can go into factory service mode. To enable,
Supervisor authentication is necessary.
Restore to Defaults Sets the device to factory defaults
Supervisor role When enabled (checkbox selected), the
Supervisor role is active. To enable,
Administrator authentication is necessary. When
disabled, the Supervisor role is inactive. To
disable, Supervisor authentication is necessary.
RADIUS user Ensure that RADIUS user names are not the
names same as local/device role names
Password Local/device roles except for Observer are
password-protected. All RADIUS users are
password-protected.
Security Alarm Settings
SETTING NAME DESCRIPTION / DETAILS
Failed A threshold number indicating when an alarm is
Authentications set off to indicate too many failed authentication
attempts
Firmware lock A Boolean value indicating if the device can
receive a firmware upgrade. If Yes and a
firmware upgrade attempt is made, the device
alarm activates. If No the device alarm does not
activate. On each firmware upgrade this setting
goes back to the default.
Settings lock A Boolean value indicating if the device can
accept any settings changes. If Yes and a
settings change attempt is made, the device
alarm activates. If No, the device alarm does not
activate.
GE Multilin C70 Capacitor Bank Protection and Control System
MIN MAX DEFAULT UNITS MINIMUM
0 (lockout 99 3
disabled)
0 (no period) 9999 3
0.0.0.0 223.255. 0.0.0.0
255.254
1 65535 514
Disabled Enabled Enabled
No Yes Yes
Disabled Enabled Disabled
No Yes No
Disabled Enabled Enabled
See RADIUS See
server RADIUS
documents server
documents
See the See the Change
Password following Me1#
Requirement password
s section section for
requireme
nts
MIN MAX DEFAULT UNITS
0 99 3
(disabled)
No Yes Yes
No Yes Yes
5.2 PRODUCT SETUP
PERMISSION
- Administrator
min Administrator
- Administrator
- Administrator
- Administrator
- Administrator
- Supervisor
(Administrator
when Supervisor
is disabled)
- Administrator
- Administrator to
enable and
Supervisor to
disable
- Administrator
Text The specified role
and Administrator,
except for
Supervisor, where
it is only itself
MINIMUM
PERMISSIONS
- Administrator
- Administrator
- Supervisor
(Administrator if
Supervisor has
been disabled)
5-17
5