GE C70 Instruction Manual page 430
Capacitor bank protection and control system ur series
Hide thumbs
Also See for C70:
- Instruction manual (702 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (624 pages)
Table of Contents
Advertisement
7.1 COMMANDS
•
What to do: Ensure the following:
–
The IRIG-B cable is properly connected.
–
Proper cable functionality (that is, check for physical damage or perform a continuity test).
–
The IRIG-B receiver is functioning.
–
Check the input signal level (it may be less than specification).
If none of these apply, then contact the factory.
MAINTENANCE ALERT:
**Bad PTP Signal**
•
Latched target message: No.
•
Description of problem: No PTP enabled port has good PTP signal input.
•
How often the test is performed: Activated when no acceptable signal is being received.
•
What to do: Ensure the following:
–
The Ethernet cable(s) are properly connected.
–
At least one PTP grandmaster-capable clock is functioning.
–
If strict PP is enabled, that entire network is PP compliant.
–
The network is delivering PTP messages to the relay.
MAINTENANCE ALERT:
Port ## Failure
•
Latched target message: No.
•
Description of problem: An Ethernet connection has failed.
•
How often the test is performed: Monitored every five seconds.
•
What to do: Check Ethernet connections. Port 1 is the primary port and port 2 is the secondary port.
MAINTENANCE ALERT:
SNTP Failure
7
•
Latched target message: No.
•
Description of problem: The SNTP server is not responding.
•
How often the test is performed: Every 10 to 60 seconds.
•
What to do: Check that Ethernet cable(s) are properly connected. Check that configuration for the SNTP server corre-
sponds to the actual server settings. Check connectivity to the server (ping the server IP address.
MAINTENANCE ALERT:
4L Discrepancy
•
Latched target message: No.
•
Description of problem: A discrepancy has been detected between the actual and desired state of a latching contact
output of an installed type "4L" module.
•
How often the test is performed: Upon initiation of a contact output state change.
•
What to do: Verify the state of the output contact and contact the factory if the problem persists.
MAINTENANCE ALERT:
GGIO Ind xxx oscill
7-12
C70 Capacitor Bank Protection and Control System
7 COMMANDS AND TARGETS
GE Multilin
Advertisement
Table of Contents
